The digital monitoring system generally uses a webcam, which is relatively simple to install. First, fix it in a specific position, and then install the network cable and router. Moreover, the network must remain open, and then connect the network cable and router with the camera. Finally, it is connected to the computer. The connection method is relatively simple. It is similar to installing a video camera on an ordinary desktop computer. Just refer to the manual directly.

Next, the installation of monitoring installation should be carried out. The basic tools to be prepared include power supply, screw, hammer, network cable pliers and so on.

The first step is to determine the area to be monitored, so as to determine the specific location of the monitoring camera to be installed, and then fix the camera on the wall or shelf with a bracket.

The second step is to determine the position of the video recording display, and then install the hard disk video recorder.

The third step is to start wiring. The camera and hard disk video recorder are connected with video cable, and BNC video heads are made at both ends of the equipment, and then the power supply wiring of the camera is provided. Moreover, each camera needs a specific power adapter to adjust the power supply.

The four step after installing the above steps, debug the camera. First connect all the wires of the whole monitoring system, and then connect the power supply. If the image can be clearly seen at this time, the installation has been successful. Then you can debug the camera according to the monitoring situation in the monitoring video. You can get the desired effect by adjusting the camera angle or focusing.