The installation of video monitoring equipment is an important guarantee for the safe operation of monitoring equipment. There is a complete set of safety video monitoring system. We have too much energy in the process of preliminary selection of suppliers, scheme of fixed plates, bargaining for acceptance and installation, and arrival of products. The later installation is ignored to a great extent, Do you know the precautions for the installation of video surveillance equipment?

Video monitoring equipment

Display installation: the display is installed stably and well ventilated. The installation position of the display shall prevent the screen from being exposed to direct external light. When light is unavoidable, the screen should be photographed. The adjustment knob of the display shall contact the position easy to operate, and a protective cover shall be added.

Installation of console: the whole console shall be installed vertically, and the equipment in the cabinet shall be positioned and reinforced after the frame is positioned. The equipment shall be installed firmly and correctly. Each fixing screw, washer and spring washer shall be firm as required and shall not be omitted. Set cable tray and air inlet according to the corresponding positions of cabinet and console. The bending radius of the cable shall be 10 times larger than the cable diameter. The console or frame is connected with the plug, the device is reliable, the installation is firm, and there is no deformation and falling off. Both ends of the cable shall be provided with appropriate number of identifications and maintenance and management signs. The control room of large safety video monitoring system shall be equipped with anti-static raised floor.

Camera installation: before installation, the camera and lens shall be adjusted for coarse adjustment and focal length after normal operation. After normal operation, the camera and lens shall be installed before installation. Check the horizontal and vertical rotation angles of the cloud platform, check the fastening of the protective cover and the operation of the wiper, and check the installation dimensions of the cloud platform and support. Do not open the lens cover when moving and setting up the camera. The installation of camera and PTZ shall be safe and stable. Power, video and control cables shall be fixed and shall not affect the rotation of the camera when leaving the room. After installation, general electric test will be carried out to check the breeze function, observe the image quality of the monitoring area, and repair after meeting the conditions.

Installation of alarm: the alarm shall be installed according to the position in the construction drawing. If there are obstacles in the installation site or area, the type of detector shall be replaced appropriately. If the deviation from the area is large, the design shall be improved and the detector shall be added. Whether the Bing installed on the slip detection detector meets the design requirements. If the angle and direction of the detector are properly adjusted in the protection area and fail to meet the design requirements after adjustment, the detector design and adjustment method shall be modified or added.